Quiet, cool and dust-free is the goal for CapCut editing, and the fans you choose decide all three more than any other cheap part.

Quick Answer

For CapCut editing, a three-pack of quality 120mm PWM fans costs about R600 to R1,200 in SA, and a single high-static-pressure 140mm fan runs R250 to R500. Aim for balanced intake and exhaust at 800 to 1,200 RPM for near-silent running rather than maxing out airflow.

Airflow vs static pressure for CapCut editing

Open mesh fronts want high-airflow fans; radiators and restrictive filters want high-static-pressure designs. Because smooth scrubbing of 4K footage leans on fast storage and a colour-accurate panel, set fans to PWM curves that idle around 600 to 800 RPM and only ramp past 1,200 RPM under load. Quality 120mm packs (think Arctic P12 or be quiet! Pure Wings) land at R600 to R1,200 for three at Evetech.

Get the intake-to-exhaust balance right

Run slightly more intake than exhaust for mild positive pressure, which keeps dust out of a build used for CapCut editing. Two front intakes plus one rear exhaust is the classic, near-silent layout for an ATX case. A single 140mm fan moves similar air to two 120mm units at lower RPM and around 20 to 25 dBA, so it is the quieter choice up top.

TIP

custom PWM curve in BIOS so fans sit near 700 RPM at idle and only spin up above 60C. Constant mid-speed fans are the real noise culprit.

FAQ

How many case fans do I actually need?

Three is the sweet spot for most ATX builds: two front intakes and one rear exhaust. Adding more past that gives diminishing airflow returns and more noise unless you run a radiator.

Are 120mm or 140mm fans better?

A 140mm fan moves comparable air to a 120mm at lower RPM, so it runs quieter, but it needs case mounts that support the larger size. Check your case spec sheet before buying.

How much do good case fans cost in SA?

Budget on R250 to R500 for a single quality 140mm PWM fan, or R600 to R1,200 for a three-pack of 120mm fans. RGB versions add roughly R150 to R300 per fan.

Map your case's fan mounts, then choose a quiet PWM set at Evetech that balances intake and exhaust for CapCut editing.