
Mouse cursor moving on its own? Isolate the input
Disconnect the mouse first, then check for pointer movement from another input. Check the tracking surface and separate the mouse from the touchpad before ordering a replacement.
Read moreWake the PC, select DisplayPort and reseat the cable before changing the monitor sleep setting. Test the monitor's sleep setting and video path before replacing the screen.
Your monitor works from a cold boot, but after the PC sleeps it reports no DisplayPort signal. Find out whether Windows resumed, whether the monitor can draw its own menu and whether the video link comes back after a change at the screen.
Wake the PC, select DisplayPort by hand and reseat the cable at both ends. These checks cost R0. If the failure happens only on wake, look in your monitor manual for its own Deep Sleep setting and try one sleep cycle with that option off.
Start with one monitor. If you normally run two, disconnect the secondary screen and note the input on the one still attached. Use a key or mouse movement to wake the PC. Listen for the usual signs it has resumed and press the monitor's menu button. The on-screen menu can appear even when the computer is sending no picture.
Choose the DisplayPort input manually if the monitor has several. Bypass a dock, switch or adapter for the first test. With the PC awake, remove and reconnect the cable. Some full-size DisplayPort plugs have a latch. Release it before pulling so you avoid straining the socket.

Check the exact model's manual. On some monitors you can adjust a separate power-saving option in the on-screen menu. Change it once, let the PC sleep, then wake it the same way you did before. If the screen comes back, repeat the cycle before you credit the change. Deep Sleep can reduce standby power, so put it back if it makes no difference.
If only one monitor on a two-screen desk has the problem, swap the cable across the two inputs if they are compatible. Keep the resolution and refresh settings steady during the trial. Moving several cables and changing the Windows plan at once makes the result hard to interpret.
A known-good cable from another setup lets you compare without buying one. If the fault follows that cable across compatible ports and screens, look in Monitor Accessories for a replacement rated for your setup. If the screen drops out with both cables, try another PC or compatible source before putting a new monitor in your cart.
When comparing Gaming Monitors, save the exact model code and look up its port, input selection and standby controls. For a dual-screen desk, add the second monitor back only once the direct connection survives a few wake cycles.
Yes. Its menu is local to the screen, so it can open when the DisplayPort input carries no image.
Start with the named option in the monitor menu, if your exact monitor supports it. The BIOS setting is a separate control.
No. Test the known-good cable through the same sleep and wake cycle.
Test a direct connection first. If direct wake works, add the dock back and repeat the test.
Yes, if both devices support HDMI. Use it as a diagnostic and check the supported display modes before making it permanent.
First reproduce the failure with a known-good connection and a second compatible source.
Where wake-up stops Test the monitor's sleep setting and video path before replacing the screen.
Yes. Its menu is local to the screen, so it can open when the DisplayPort input carries no image.
Start with the named option in the monitor menu, if your exact monitor supports it. The BIOS setting is a separate control.
No. Test the known-good cable through the same sleep and wake cycle.
Test a direct connection first. If direct wake works, add the dock back and repeat the test.
Yes, if both devices support HDMI. Use it as a diagnostic and check the supported display modes before making it permanent.
First reproduce the failure with a known-good connection and a second compatible source.