Quick Answer
A Windows 11 update can cause cursor skips, aim stutter, or polling-rate drops, but the fix is usually driver order, USB signal path, or firmware rather than replacing the whole wireless gaming mouse. Start with 1,000Hz polling and a receiver extender, then test directly from a rear motherboard port for 15 minutes.
First Checks
Unplug extra hubs, restart, and test the device with the simplest profile possible. If the problem disappears, the accessory is not the first thing to replace. A new R1,200-R4,000 device only makes sense after the same fault appears on two ports and, where possible, on a second PC.
Driver And Firmware Order
Install the motherboard chipset package first, then the device software, then receiver or headset firmware. On X870 and X870E boards, BIOS updates can include USB stability fixes, so check the board support notes before blaming the mouse or headset. Keep RGB tools and audio suites minimal while testing.
SA Desk Setup Notes
Many SA desks place the tower under a table or behind a cabinet, which is bad for 2.4GHz receivers. Put the receiver within 20-30cm of the device using the supplied extender. For voice chat, use 48kHz and avoid stacking several noise filters at once.
FAQ
Should I replace the wireless gaming mouse immediately?
No. Replace it only after direct-port testing, firmware updates, and a second-device check confirm hardware failure. Most post-update stutter cases are solved before buying new gear.
Which setting should I test first?
Use 1,000Hz polling and a receiver extender as the baseline. It gives you a stable reference so you can see whether the fault is Windows, USB, software, or the device.
Can the motherboard cause this problem?
Yes. USB controller behaviour, chipset drivers, and front-panel cabling can all cause stutter even when the accessory is fine. Rear ports on a board such as Logitech G Pro X Superlight 2 or Razer DeathAdder V3 Pro are the cleanest test point.
Pro Tip
Run one clean 15-minute test with the receiver on the desk; if the wireless gaming mouse becomes stable, keep the layout and skip the replacement.